Eight Outputs
The G-01X can supply a clock signal to a maximum of eight devices. Output can be switched ON and OFF for each terminal. The unit has four 10 MHz sine wave clock output terminals. The other four output terminals (A × 2 and B × 2) enable clock signals to be output at 100 kHz, 10 MHz (square wave), and the basic frequency of 44.1 kHz/48 kHz, up to a maximum frequency of 22.5792 MHz/24.576 MHz, and separate output frequencies can be set for each terminal.
The Specs
Clock outputs CLOCK OUT 44.1 kHz setting 44.1, 88.2, 176.4, 352.8, 705.6 kHz 1.4112, 2.8224, 5.6448, 11.2896, 22.5792 MHz 48 kHz setting 48, 96, 192, 384, 768 kHz 1.536, 3.072, 6.144, 12.288, 24.576 MHz Both settings 100 kHz, 10 MHz Connectors BNC x 4 Output level Rectangular wave: TTL level / 75 Ω 10MHz OUT 10 MHz Connectors BNC x 4 Output level Sine wave: 0.5 ± 0.1 Vrms / 50 Ω Master clock input (EXT IN) Input frequency 1pps mode 1pps signal (GPS precision or better) 10M mode 10MHz (GPS precision or better) Connector BNC x 1 Input levels 10MHz Sine wave: 0.5-1.0 Vrms/50 Ω
Square wave: TTL level/10 kΩ 1pps signal Positive pulse: TTL level/10 kΩ Rubidium oscillator Until oscillator stabilizes after power turned on 10 minutes Frequency stability Within ±0.1 ppb (-20°C to +65°C) Frequency precision Within ±0.05 ppb (when shipped new)(ppb = 10
-9) General Power supply AC 230V, 50Hz
AC 120V, 60Hz
AC 220V, 60Hz Dimensions
(W x H x D)
(including protrusions) 445 x 131 x 359 mm
(17 5/8″ x 5 1/4″ x 14 1/4″) Weight 13.3kg (29 3/8 lb) Included accessories Power cord x 1, Felt pads x 3, Owner's manual x 1, Warranty card x 1