Free shipping on orders over $100!
The VPI Cliffwood is now available in Black in addition to their Chocolate Truffle and White finishes! The Cliffwood is a fine way to get your vinyl listening started. It can either replace an older turntable or be a very nice first step into becoming a vinyl junkie! Here what all the talk is about for yourself with the Cliffwood!VPI is also excited to be teaming up with Grado Labs! VPI engineered a cartridge shell specifically for the Grado to make it easier to mount and contribute to the sound signature. The VPI/Grado Green will be the factory standard mounted cartridge on all VPI Cliffwood turntables.
1.25”" thick textured vinyl covered non-resonant MDF chassis.
16" x 11" footprint
19” x 14” x6” overall size
Platter rotates on an oil bath bearing
The bearing has a PEEK thrust disc and machined graphite impregnated brass bushings using a Thompson Engineering 60 Rockwell case hardened shaft.
New 9” vertical Yoke type tonearm with lateral type bearing.
Pivot to spindle: 223mm
Effective length: 240.7mm
Offset angle: 22.85 degrees
Average RMS distortion: .36%
Damped machined aluminum armtube.
Very pure copper wire, twisted with special insulating jacket.
The armbase is upgradeable to a standard JMW 9 arm.
Type Belt drive (manual turntable)
Motor 600 RPM AC Motor - 2 speed pulley
Turntable Platter Aluminum
Diameter 11.81” (30.0 cm)
Turntable Speeds 33.3 RPM and 45 RPM
Cartridge VPI/Grado Green
Dimensions 18.5” (470 mm) W x 13.5” (343 mm) D x 4.3” (109 mm)H
Weight 12.9 lbs. (5.9 kg)
Frequency Response: 10-50 Principal: MI Channel Separation at 1KHz: 30 Input Load: 47K Output at 1KHz (5CM/sec.): 5mV Recommended Tracking Force: 1.5 Stylus Type: Elliptical Inductance: 45mH Resistance: 475 Compliance CUs: 20 Stylus Replacement (U=user): U
Back to top